So it was only working on 32bit, and not all cars were able to be scanned. On 64bit machines to work with PassThru interfaces, but Vas5054 didn´t have this drivers, Then, the same software that it works under 32bit if on 64bit will work also.įor example Xentry on 32bit fail to open Euro 5/6 cars, this is because Xentry is to be installed This way you will have the 1Gen interface (blue & yellow) listed as availableįor any software working with passthru ( under 64bit ), just select it and start working. Your interface will not be listed as a PassThru interface, so you must install it. If this software “I+ME-Actia-PassThru-XS-Driverpack-xx1” is not installed than Power down, power up install driver,and is done. One more time the process, if you see the serial number on the driver name , The interface, power it up again, if asking again for drivers just repeat It will confirm Updated Driver software success, next remove power from It will open a red windows security about the publisher, justĬlick “”Install this driver software anyway”” Than click “NEXT” it will give you driver warning, press “Yes”, Go to device manager and chose update drivers for Passthru+ XS,Ĭhose “”Browse my computer for driver software”” Is not recognized, for Multi-Diag Actia-Connect use a 32bit OS.ġº install –I+ME-Actia-PassThru-XS-Driverpack-xx1–Ģº install –I+ME-Actia-PassThru-XS-Driverpack-xx2– It will not work with Actia Multidiag software, because the interface This modified drivers are only to work as PassThru under 64bit, No need to disable Anti_Virus, and i strong advise you to do a virus scan on this folder. !0GhQSajL!g3Z1cPqoN2kizCJ13q-Njtd7MXqn9-NExznxIxxTBEc Since there is no official drivers for this interface, i have also change the drivers for This are drivers to make the VAS 5054 A interface work as PassThru under 64bit machine, In order to make sure you are downloading the exact right driver the hardware id is USB/VID103a&PIDf008. This Windows driver was developed by ACTIA. USB Com Board Evolution Driver Multi-instance is a WdmUSB hardware device.

Recommended and tested by major OEM's, the PassThru+ XS 2G kit is a VCI enabling you to communicate with and reprogram vehicle ECU's according to the J2534 & J2534-1 specifications. Actia's PassThru+ XS 2G kit is fully compliant to J2534-1 & J2534-2. Welcome screen will appear: Select USB, “1st Device”, then press Next. Connect device to PC with USB cable, power it on by connecting to the car or via OBD. To be able to work with Actia PassThru device in Lexia 3 and PPO software you need to reprogram (flash) device. Tips and guides: VAS5054 A Windows 64 bit install

Actia Usb Com Board Driver